Indicator And Warning Lights - Yamaha Neo's YN50 Owner's Manual

Indicator and warning lights

1. 2-stroke engine oil level warning light "
2. High beam indicator light "
3. Turn signal indicator light "
4. Fuel level warning indicator "
Turn signal indicator light "
This indicator light flashes when the
turn signal switch is pushed to the left
or right.
High beam indicator light "
This indicator light comes on when
the high beam of the headlight is swit-
ched on.
INSTRUMENT AND CONTROL FUNCTIONS
EAU11004
Oil level warning light "
This warning light comes on when the
key is in the "
level in the 2-stroke engine oil tank is
low during operation. If the warning
light comes on during operation, stop
immediately and fill the oil tank with
2-stroke engine oil of either JASO
grade "FC" or ISO grades "EG-C" or
"EG-D". The warning light should go
off after the 2-stroke engine oil tank
has been refilled.
"
"
"
TIP
"
If the warning light does not come on
when the key is in the "
EAU11020
" or does not go off after the 2-stroke
engine oil tank has been refilled, have
a Yamaha dealer check the electrical
circuit.
EAU11080
"
NOTICE
Do not operate the vehicle until you
know that the engine oil level is suf-
ficient.
EAUM1062
" Fuel level warning light "
This warning light comes on when the
" position or if the oil fuel level drops below approximately
1.4 L (0.37 US gal, 0.31 Imp.gal).
When this occurs, refuel as soon as
possible.
The electrical circuit of the warning
light can be checked by turning the
key to "
come on for a few seconds, and then
go off.
If the warning light does not come on
initially when the key is turned to "
or if the warning light remains on,
have a Yamaha dealer check the elec-
" position
trical circuit.
ECA16291
3-2
EAU11352
"
". The warning light should
",
3