Troubleshooting - Hunter M3544-01 Manual

Troubleshooting

Fan doesn't work
• Make sure power switch is on.
• Pull the pull chain to make sure it
is on.
• Push the motor reversing switch
firmly left or right to ensure that it
is engaged.
• Check the circuit breaker to
ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 9.
• Make sure the battery is working.
• Check the plug connection in the
switch housing.
CFL bulbs flicker or do not dim
• Turn the power switch off and
back on. Within three minutes,
hold down the Fan Off button
while pressing the Light
button twice. If the problem
is not corrected, repeat the
process up to three times.
Noisy operation
• Tighten the blade and blade iron
screws until they are snug.
• Check to see if any of the blades
are cracked. If so, replace all of
the blades.
M3544-01 • 09/24/13 • © Hunter Fan Company
Remote control of fan is erratic
• Make sure the battery is
installed correctly.
• Install a fresh battery.
Transmitter only works when
held at close range
• Install a fresh battery.
If you have multiple remotes or
multiple remote-controlled fans
installed on the same circuit
breaker and you are experiencing
interference or faulty operation of
your remote controls, please go to
www.HunterFan.com/FAQs
and click "How do I properly install
multiple remote-controlled fans?"
for information on how to correct
this issue.
18
www.HunterFan.com
1.888.830.1326
Excessive wobbling
• Tighten all of the blade and
blade iron screws until they
are snug.
• Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
• Use the provided balancing
kit and instructions to balance
the fan.