Audio Setup - Sony NXCAM NEX-FS700U Operating Manual

b Notes
• Super Slow Motion recording is available only
when the AUTO/MANUAL switch D is set to
MANUAL. Note that iris, gain and shutter
speed are fixed to manual.
• When selecting [960] ([800]) on [FRAME
RATE], the image to be displayed and recorded
is approximately half the field angle.
• When selecting [480], [960] ([400], [800]) on
[FRAME RATE], the image quality is
deteriorated compared with the image with
normal recording.
• If you adjust the gain or shutter speed, or change
the white balance during Super Slow Motion
recording, the image on the LCD screen
changes. However, the camera setting at the
time the recording ends is reflected in the
recorded image.
• You cannot change the frame rate during Super
Slow Motion recording. To change the frame
rate, stop current Super Slow Motion recording.
• The time code is recorded in the [REC RUN]
mode during Super Slow Motion recording
(p. 100).
• The Super Slow Motion is canceled
automatically when the POWER switch is set to
OFF, but the frame rate setting is retained.
• Flicker adjustment is not effective during Super
Slow Motion recording.
• You cannot record sound.
• The simultaneous recording on the memory card
and the flash memory unit is not available.
• You cannot select a shutter speed value slower
than the frame rate.
• You cannot use the
during Super Slow Motion recording.
(one push) button

Audio setup

The following jacks, switches and dials
allow you to set the sound to be recorded.
See page 26 on connecting the
microphones.
External audio jacks and switches
INPUT 1 jack E
INPUT 2 jack J
INPUT 1 switch A
INPUT 2 switch F
Audio source switches
CH1 (INPUT 1/INPUT 2) switch B
CH2 (INPUT 1/INPUT 2) switch G
Audio level controls
CH1 (AUTO/MAN) switch C
CH2 (AUTO/MAN) switch H
AUDIO LEVEL (CH1) dial D
AUDIO LEVEL (CH2) dial I
53
Continued ,