Sony NXCAM NEX-FS700U Operating Manual page 125

• Be sure to set the POWER switch to OFF when
not recording or playing back on your
camcorder. The battery pack is also consumed
when your camcorder is in recording standby or
playback pause.
• Have spare battery packs ready for 2 or 3 times
the expected recording time, and make trial
recordings before making the actual recording.
• Do not expose the battery pack to water. The
battery pack is not water resistant.
About the remaining battery indicator
• Check the level with the following indicators
and % displayed on the LCD screen.
Battery remaining
indicator
• The displayed level may not be correct under
certain circumstances.
• When the power goes off even though the
remaining battery time indicator indicates that
the battery pack has enough power to operate,
charge the battery pack fully again. Remaining
battery time will be indicated correctly. Note,
however, that the battery indication will not be
restored if it is used in high temperatures for a
long time, or if left in a fully charged state, or
when the battery pack is frequently used. Use
the remaining battery time indication as a rough
guide only.
About storage of the battery pack
• If the battery pack is not used for a long time,
fully charge the battery pack and use it up on
your camcorder once a year to maintain proper
function. To store the battery pack, remove it
from your camcorder and put it in a dry, cool
place.
• To discharge the battery pack on your
camcorder completely, leave your camcorder in
recording standby until the power goes off.
%
61% to 100%
41% to 60%
21% to 40%
1% to 20%
-
About battery life
• Battery capacity decreases over time and
through repeated use. If decreased usage time
between charges becomes significant, it is
probably time to replace it with a new one.
• Each battery's life is governed by storage,
operating and environmental conditions.
About charging the battery pack
• Use the Charger (supplied) to charge the
designated batteries only. If you charge other
types of batteries, those batteries may leak, heat
up, burst, or give an electric shock, resulting in
burns or injury.
• Remove the charged battery from the Charger.
• The CHARGE lamp of the supplied Charger
flashes in 2 patterns as follows:
Fast-flashing...Turns on and off rapidly at about
0.15-second intervals.
Slow-flashing...Turns on and off alternately for
about 1.5 seconds, and turns off completely for
about 1.5 seconds. The lamp repeats this
sequence.
• If the CHARGE lamp is fast-flashing, remove
the battery that is being charged, and then re-
attach the same battery again firmly. If the
CHARGE lamp continues fast-flashing, the
cause could be that the battery is damaged, or
the battery is not a designated type. Check the
battery to confirm whether it is a designated
type or not. If it is a designated type, remove the
battery first, and then attach a brand-new battery
or another known-to-be-good battery to see if
the Charger is working correctly. If the Charger
is working correctly, the cause could be that the
battery is damaged.
• If the CHARGE lamp is slow-flashing, the
Charger is in standby mode and charging is
suspended. When the ambient temperature is out
of the appropriate temperature range for
charging, the Charger suspends charging
automatically and enters standby mode. When
the ambient temperature returns to an
appropriate temperature, the Charger restarts
charging and the CHARGE lamp lights up. We
recommend charging the battery pack in an
ambient temperature of from 10 °C to 30 °C
(50 °F to 86 °F).
125
Continued ,