Sony NXCAM NEX-FS700U Operating Manual page 115

Connecting to TV
Neither image nor sound is played back on the TV connected with the
component video cable.
• Set [VIDEO OUT] according to the requirements of the connected device (p. 92).
• When you are using the component video cable, make sure that you connect the red and white
plugs of the A/V connecting cable (p. 72).
Neither image nor sound is played back on the TV connected with the HDMI
cable.
• Images are not output from the HDMI OUT jack, if copyright protection signals are recorded
in the images.
• Signals are not output from the HDMI OUT jack when the USB jack is connected.
Neither image nor sound is played back on the TV, projector, or AV amplifier
connected with the HDMI cable.
• If you cannot view images or hear sound on the TV, projector, or AV amplifier connected
with the HDMI cable, try disconnecting and connecting the HDMI cable, or turn on your
camcorder again.
The image appears distorted on the 4:3 TV.
• This happens when viewing a movie recorded in the 16:9 (wide) mode on a 4:3 TV. Select
(REC/OUT SET) t [VIDEO OUT] t [DOWN CONVERT TYPE] t the
appropriate down conversion type (p. 93).
Black zone appears at top and bottom of a 4:3 TV screen.
• This happens when viewing a movie recorded in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
Copying/Editing/Connecting to other devices
Time code and other information appear on the display of the connected
device.
• Set [DISPLAY OUTPUT] to [LCD PANEL] when you connect a device with the A/V
connecting cable (p. 98).
Copy cannot be done correctly using the A/V connecting cable.
• The A/V connecting cable is not connected properly. Make sure that the A/V connecting
cable is connected to the input jack of the device.
Sound cannot be added to the recording media after recording.
• You cannot add sound to the recording media after recording on your camcorder.
115
Continued ,