4. If applicable, touch inside the Amplitude data entry field and enter
a value, using the slider bar at the bottom of the window. Click the
keypad button (as follows) on the slider bar to enter a value using
the pop‐up numeric keypad.
5. Touch inside the Frequency data entry field and enter a value, using
the slider bar at the bottom of the window. Click the keypad button
(as follows) on the slider bar to enter a value using the pop‐up
numeric keypad.
Date and Time
From the Date and Time tab on the Utilities dialog, you can manually set
the time and date or get it from the Internet. If you elect to get the date
and time from the Internet, you need to have the oscilloscope connected
to the Internet through the LAN connector on the side panel. You can also
set time zones and daylight savings time.
Setting the Date and Time Manually
1. Touch Utilities → Utilities Setup on the menu bar.
2. Touch the Date/Time tab.
3. Touch inside each of the Hour, Minute, Second, Day, Month, and
Year data entry fields and enter a value, using the pop‐up numeric
keypad.
4. Touch the Validate Changes button.
Setting the Date and Time from the Internet
Note: The Simple Network Time Protocol (SNTP) is used.
1. Ensure that the oscilloscope is connected to the Internet through
the LAN connector at the side of the oscilloscope.
2. Touch Utilities → Utilities Setup on the menu bar.
3. Touch the Date/Time tab.
4. Touch the Set from Internet button.
WM8Zi‐GSM‐E RevA
Getting Started Manual
162