Hitachi C 10FSH Handling Instructions Manual page 25

Fence
A
Table on Base
(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 35 (see Fig. 41; tilt the head
to the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (B in Fig. 34) contacts the
fence as indicated Fig. 43.
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 35 (see Fig. 42; tilt the head
to the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (A in Fig. 34) contacts the
fence as in Fig. 44.
Head
4
Miter Angle
Scale
Fence
B
Fig. 39
Bevel Angle
Scale
1
Fence
Base
Turntable
Fig.41
B
Table on Base
Fig. 43
Fence
B
Table on Base
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Fence
Turntable
A
A
Fig. 40
Head
3
Base
Miter Angle
Scale
Fig. 42
Fence
A
Table on Base
Fig. 44
Bevel Angle
Scale
2
B
25