30° And 33.9° Left Slant Setting Method - Hitachi C 10FSH Handling Instructions Manual

30° and 33.9° left slant setting method
Fixing pin Holder (A)
Push
Bevel Scale
Indicator
(for left bevel scale)
Fig. 36
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 35 (see Fig. 37; tilt the motor
head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (A in Fig. 34) contacts the
fence as indicated in Fig. 39.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 35 (see Fig. 38; tilt the head
to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (B in Fig. 34) contacts the
fence as in Fig. 40.
1
Miter Angle Scale
24
Clamp Lever
Tighten
Loosen
Head
Bevel Angle Scale
4
Fence
Base
Turntable
Fig. 37
(1) Loosen the clamp lever and slant to the left a
little at a time while pushing the fixing pin into
the main unit. At this time, the fixing pin will
enter one step and fit into the 30° left slant and
33.9° left slant setting slots.
(2) With the fixing pin in the slot as described
above, setting to the 30° left slant position is
possible by pushing to the right side.
(3) Also, with the fixing pin in the slot as described
above, setting to the 33.9° left slant position is
possible by pushing to the left side.
(4) Look at the bevel scale and indicator to recheck
whether or not the settings match and then
tighten the clamp lever.
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
2
Fence
Miter Angle Scale
Head
Bevel Angle Scale
3
Base
Turntable
Fig. 38