Table of Contents
Advertisement
OPERATING INSTRUCTIONS (continued)
Using the HDTV Menu Screen
1. Make sure the physical connection is properly connected.
2. Switch on the TV.
3. Select the HDTV input on your TV by using the remote control.
4. If the PDP is moved to a different location. You should reset the receiver and do the channel scanning all over again.
USING THE HDTV ON-SCREEN DISPLAY (OSD) CONTROLS
1. Press DTT MENU on the remote control to display the MENU banner.
2. Use the ▲▼
to navigate to different menu item.
3. Use the
to adjust functions.
4. Press ENTER on the remote control to select functions. Press RTN to jump back the last page of menu.
5. Press RTN on the remote control to go to the last page; press EXIT to quickly exit from the menu.
HDTV Main Menu
Edit Channel
TV Main List
No Block
Block G and above
Block PG and above
Block M and above
Parental Guidance
Block MA and above
Block AV and above
Block R and above
Block All
Manual Scan
Installation
Quick Scan
Auto Scan
Restore Defaults
Audio Setup
Option Setup
General Setting
Change Pin
Local Time
System
Status
36
This is used to edit the channel from the TV channel list.
Blocks selected HDTV-rating and all ratings below it.
(Enter the password to change setting).
Search scan TV channel by channel number, frequency, bandwidth and
priority
Search scan TV channel by your location
Automatically search scan TV channel
Sets HDTV back to default settings
Adjusts HDTV audio setting
Adjusts HDTV OSD display setting
To change password
Sets your local time
Shows the software version of your set
Advertisement
Table of Contents
