Table of Contents
Advertisement
Change phone to admin mode: Press MENU/BACK[7. User Type. Press the RIGHT
navigation key until you see "admin" on the screen. Then press the DOWN key to
be prompted for the password. It is "admin" by default. Type and press OK.
Network Settings: Press MENU/BACK[3. SETTINGS[2. ADVANCED[OK. Enter
the admin password, and choose NETWORK->WAN PORT or VLAN or WEB TYPE or
802.1x Settings to enter the internet relating configuration page.
Account Settings: Press MENU/BACK[3. SETTINGS[2. ADVANCED[OK. Enter the
admin password, and choose ACCOUNTS[OK to configure the account settings.
Enter the following parameters:
Field
Activation
Label
Display Name
Register Name
User Name
Password
SIP Server
Press the UP and DOWN buttons to scroll through the parameter list and fill in
proper information. Press the OK button to confirm.
Note:
The active User Type is shown with an * on the left of display when you enter MENU/
BACK[7. User Type MENU/BACK, like this:
Once you finish all admin related tasks you should change back to user mode with
the same procedure.
Description
Enable/disable the account
What the phone will display on the other phone's Caller ID.
This may be overridden by data at the service provider.
The local phone name showing on the other phone
when calling
Register name provided by your service provider.
User name provided by your service provider.
Account password provided by your service provider.
SIP server address provided by your service provider.
<*user >
11
10
Advertisement
Table of Contents
