Connector And Jumper Description; Mounting Orientation; Figure 27. Mounting Hole Locations Of All Models Except 60 Gb Model - Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive Specifications

Figure 27. Mounting hole locations of all models except 60 GB model.

6.5.3 Connector and jumper description

A jumper is used to designate the drive address as either master or slave. The jumper setting method is
described in section 7.10, "Drive address setting" on page 58.
Connector specifications are included in section 7.2, "Interface connector" on page 41.

6.5.4 Mounting orientation

The drive will operate in all axes (six directions) and will stay within the specified error rates when tilted
±5 degrees from these positions.
Performance and error rate will stay within specification limits if the drive is operated in the other permis-
sible orientations from which it was formatted. Thus a drive formatted in a horizontal orientation will be
able to run vertically and vice versa.
The recommended mounting screw torque is 3.0±0.5 kgf-cm.
The recommended mounting screw depth is 3.0±0.3 mm for bottom and 3.5±0.5 mm for horizontal
mounting.
Hitachi Travelstar 60GH & 40GN hard disk drive specifications
32