Jumper Socket Setting; Jumper Connector Layout - Hitachi Ultrastar SCSI Interface HUS103014FL3600 Oem Manual

12 Jumper Socket setting

12.1 Jumper connector layout

WIDE LVD drive
Force Single-Ended bus mode (11)
Disable Auto Start (9)
Figure 12.1 Jumper connector layout (WIDE LVD drive)
Note 1. Green or White jumper sockets are used for the customer's selection. (They are
shown with thick lines in figure 13.1)
2. Shaded jumper sockets are default setting at the factory.
3. Reserved pins (C3-17,19; C4-2,4,6) are used at the factory. Installing or
removing jumper sockets on these reserved pins will void any warranties of the
HDD.
Do not connect an assigned pin to another assigned pin.
4. Jumpers are installed at C3-2,4 & 6,8 & 10,12 & 14,16 & 18,20 as spares.
Customer can remove and use them for another jumper settings.
Option Jumper Connector (C3)
ID0 (7)
ID1 (5)
ID2 (3)
ID3 (1)
1
2
Enable Delayed Start (13)
Write Protect (15)
Reserved (17)
Reserved (19)
LED(with 0ohm) (21)
Term. Power to SCSI Bus (23,24)
23
GND (2,4,6,8,10,12,14,16,18,20)
24
5V(with 150ohm) (22)
Auxiliary Connector (C4)
ID0 (1)
ID1 (3)
ID2
(5)
ID3 (7)
Drawing No. Sheet No. Revision
K6610091
Reserved (2)
Reserved (4)
Reserved (6)
LED (8)
GND (10)
2 12
1 11
Write Protect (12)
5V (11)
N.C. (9)
38/43 2005/2/23