6.4.2 Mounting hole locations
The mounting hole locations and size of the drive are shown below.
6.4.3 Connector and jumper description
A jumper is used to designate the drive address as either master or slave. The jumper setting method is described in
Section 7.10, "Drive address setting" on page 55.
Connector specifications are included in Section 7.2, "Interface connector" on page 39.
6.4.4 Mounting orientation
The drive will operate in all axes (six directions) and will stay within the specified error rates when tilted ±5degrees
from these positions.
Performance and error rate will stay within specification limits if the drive is operated in the other permissible ori-
entations from which it was formatted. Thus a drive formatted in a horizontal orientation will be able to run verti-
cally and vice versa.
The recommended mounting screw torque is 3.0±0.5 kgf-cm.
Travelstar 5K100 Hard Disk Drive Specification
31