Table of Contents
Advertisement
12 Jumper Socket setting
12.1 Jumper connector layout
WIDE LVD drive
Force Single-Ended bus mode (11)
Disable Auto Start (9)
Figure 12.1 Jumper connector layout (WIDE LVD drive)
Note 1. Green or White jumper sockets are used for the customer's selection. (They are
shown with thick lines in figure 13.1)
2. Shaded jumper sockets are default setting at the factory.
3. Reserved pins (C3-17,19; C4-2,4,6) are used at the factory. Installing or removing
jumper sockets on these reserved pins will void any warranties of the HDD.
Do not connect an assigned pin to another assigned pin.
4. Jumpers are installed at C3-2,4 & 6,8 & 10,12 & 14,16 & 18,20 as spares.
Customer can remove and use them for another jumper settings.
Option Jumper Connector (C3)
ID0 (7)
ID1 (5)
ID2 (3)
ID3 (1)
1
2
Enable Delayed Start (13)
Write Protect (15)
Reserved (17)
Reserved (19)
LED(with 0ohm) (21)
Term. Power to SCSI Bus (23,24)
23
GND (2,4,6,8,10,12,14,16,18,20)
24
5V(with 150ohm) (22)
Auxiliary Connector (C4)
ID0 (1)
ID1 (3)
ID2
(5)
ID3 (7)
Drawing No. Sheet No. Revision 5
K6602906
Reserved (2)
Reserved (4)
Reserved (6)
LED (8)
GND (10)
2
12
1
11
Write Protect (12)
5V (11)
N.C. (9)
39/46
2003/6/12
Advertisement
Table of Contents
