Introduction; Network Interface; Serial Interface; Leds - Bosch Conettix ITS-D6682-INTL Installation Manual

.
Trademarks
® ®
Microsoft Windows 2000, XP, Vista™, and
®,
MS-DOS are either registered trademarks or
trademarks of Microsoft Corporation in the United
States and/or other countries.

1.0 Introduction

The Conettix D6682 Ethernet Network Adapter is a
two-channel network adapter. Most networked
installations only have one configured channel.
Follow these instructions to avoid the
possibility of harm to the operator, or
damage to the equipment.
1.1

Network Interface

Figure 1: Power/Ethernet
1- Ethernet Link LED
2- RJ45 Ethernet Jack
3- Ethernet Activity LED
4- Reset Pin
5- Power Plug
Bosch Security Systems, Inc. | 2/09 | F01U126778-01
Conettix ITS-D6682-INTL | Installation Guide | 1.0 Introduction
1.2

Serial Interface

Figure 2: D6682 Network Interface
1- Power/Diagnostic LEDs
2- Serial Port 2 (DTE) – optional (use supplied
cable if required)
3- Serial Port 1 (DTE) – use supplied null cable
1.3

LEDs

Table 1: D6682 LEDs
LED
Power/Diagnostic
(Blue)
RX Serial 1 Activity
(Green)
TX Serial 1 Activity
(Yellow)
RX Serial 2 Activity
(Green)
TX Serial 2 Activity
(Yellow)
Ethernet Link
(Bi-color LED on left)
Ethernet Activity
(Bi-color LED on
right)
Description
Steady On: Power OK
Blinking 2x: No DHCP
response
Blinking 2x: Setup Menu active
Off: No data activity
Blinking: Data received by
D6682 on Channel 1
Off: No data activity
Blinking: Data transmitted from
D6682 on Channel 1
Off: No data activity
Blinking: Data received by
D6682 on Channel 2
Off: No data activity
Blinking: Data transmitted from
D6682 on Channel 2
Off: No Ethernet link
established
Solid Yellow: 10 Mbps
Ethernet link established
Solid Green: 100 Mbps
Ethernet link established
Off: No data activity
Solid Yellow: Half Duplex data
activity
Solid Green: Full Duplex data
activity
3