Optional Blower Installation - Breckwell The Mahogany Wood Stove Manual

Optional Blower Installation

WARNING: Electrical Grounding Instructions. This appliance is equipped with a three‐prong (grounding) plug
for your protection against shock hazard and should be plugged directly into a properly grounded three‐prong
receptacle. Do not cut or remove the grounding prong from this plug.
The blower kit contains a blower assembly and speed control unit.
W3100 ‐ Freestanding Units
WARNING: Never operate the stove without either the blower or the blower cover in place.
1. With a hammer remove the two knockouts in
the rear bottom of the firebox.
2. Insert the two 1/4‐20 x 1" bolts with washer
and partially tighten.
3. Hold the blower on both sides and allow the
screw heads to go through the slots and move
the blower to the right as much as possible.
4. Tighten bolts with 7/16" wrench.
5. Route the fan cord so that it is not coming into
contact with any part if the stove.
W3100 ‐ Insert Units
WARNING: Never operate the stove without either the blower or the blower cover in place.
1. Remove the cover plate under the ash lip with
5/32" allen wrench.
2. Remove the top cover of blower housing by
removing the 6 hex head screws holding it in
place.
3. Insert the two 1/4‐20 x 1" bolts with washer and
partially tighten.
4. Hold the blower on both sides and allow the
screw heads to go through the slots and move
the blower to the right as much as possible.
5. Tighten bolts with 7/16" wrench.
6. Route the fan cord so that it is not coming into
contact with any part if the stove.
America's Favorite Stoves Since 1980
Chapter 3
Installation
Page 10