Management Setup; Configuring Administrator Account - EnGenius User Guide User Manual

B N S M S
ASIC ETWORK ETTINGS ANAGEMENT ETUP

4.5 Management Setup

The Management section lets you configure administration, management VLAN, SNMP settings, backup/restore settings, firmware
upgrade, time settings, and log settings. This chapter describes these settings.

4.5.1 Configuring Administrator Account

Click the Administration link under the Management menu to change the user name and password used to log on to the ENS202
Web Configurator. The default user name is admin and the default password is admin. Changing these settings protects the
ENS202 configuration settings from being accessed by unauthorized users.
New Name Enter a new username for logging in to the Web
Configurator.
New Password Enter a new password for logging in to the Web
Configurator
Confirm Password Re-enter the new password for confirmation.
Click Save/Apply to apply the changes or Cancel to return previous settings.
Remote Management Enable or disable remote management.
Remote Upgrade Specify whether the ENS202 firmware can be
upgraded remotely.
Remote Management Port If remote management is enabled,
enter the port number to be used for remote management. For example: If you specify the port number 8080, enter http://<IP
address>:8080 to access the ENS202 Web Configurator.
Click Accept to apply the changes or Cancel to return previous settings.
4-41