Advertisement
ASSEMBLY
Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until
assembly is completed. Read each assembly step before you begin. During assembly, make sure that all parts
are oriented as shown in the drawings. A Phillips screwdriver (not included) and two spanners (not included)
are required for assembly.
1. Before beginning assembly, make sure that you
have read and understand the information
above.
Press two 1 1/2" Round Outer Caps (9) onto the
Frame (1). Press a 1 1/2" Square Inner Cap (10)
into the Frame.
Attach the Backrest (3) to the Frame (1) with four
M6 x 16mm Screws (5).
2. Press a 1 1/2" Square Inner Cap (10) into the Leg
(2).
Attach the Leg (2) to the Frame (1) with two M10 x
57mm Bolts (12) and two M10 Nylon Locknuts (13).
3. Press four 3/4" Round Inner Caps (11) into the two
Pad Bars (4). Press two 1 1/2" Round Outer Caps
(9) onto the Adjustment Foot (8).
Slide a Pad Bar (4) into the upper hole in the Leg
(2). Slide the two Small Foam Pads (6) onto the
Pad Bar.
Slide the Adjustment Foot (8) into the Leg (2) with
the decal in the indicated position. Slide the remain-
ing Pad Bar (4) into the lower hole in the Leg and
the Adjustment Foot. Slide the two Large Foam
Pads (7) onto the Pad Bar.
1
10
2
13
2
3
6
2
7
8
9
4
3
1
5
5
9
10
12
1
6
11
11
4
11
11
9
Warning Decal
9
7
Advertisement
