ZyXEL Communications P-27xx Series User Manual page 32

Chapter 4 Maintenance
Click Maintenance > System > General to open this screen.
Figure 11 System General
The following table describes the labels in this screen.
Table 9 System General
LABEL
System Setup
Mode
Administrator
Inactivity Timer
Manager IP
Address
Administrator/User Account
User Name
User Password
Apply
Reset
32
DESCRIPTION
Select Router to set the ZyXEL Device to router mode.
Select Bridge and configure the Manager IP Address to set the
ZyXEL Device to bridge mode.
Type how many minutes a management session (either via the web
configurator or telnet) can be left idle before the session times out. The
default is 5 minutes. After it times out you have to log in with your
password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter
how long it has been left idle (not recommended).
Enter the management IP address of the ZyXEL Device if it is in bridge
mode.
Type the user name you use to access the system.
Type your new system password (up to 30 characters). Note that as you
type a password, the screen displays a dot for each character you type.
After you change the password, use the new password to access the
ZyXEL Device.
Click this to save your changes and then return to the previous screen.
Click this to reset the options in this screen to their defaults.
P-27XX Series User's Guide