Step 10 Before Lighting The Stove; Step 11 Lighting The Stove; After The Installation - Heat & Glo Townsend I Installer's Manual

Step 10
Before Lighting
the Stove
Step 11
Lighting the
Stove
After the
Installation
Before lighting the stove, be sure to do the following:
Review safety warnings and cautions
• Read the Safety and Warning Information section
at the beginning of this Installers Guide .
Double-check for gas leaks
• Before lighting the stove, double-check the unit for
possible gas leaks.
Double-check vent terminations for obstruc-
tions.
• Before lighting the stove, double-check the unit for
possible obstructions that could be blocking the
vent terminations.
Double-check for faulty components
• Any component that is found to be faulty MUST BE
replaced with an approved component. Tampering
with the stove components is DANGEROUS and
voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the stove, it will take a few minutes
for the lines to purge themselves of this air. Once the
purging is complete, the stove will light and will
operate normally.
Subsequent lightings of the stove will not require this
purging of air from the gas supply lines, unless the
gas valve has been turned to the OFF position, in
which case the air would have to be purged.
You've reviewed all safety warnings, you've checked
the stove for gas leaks, you know the vent system is
unobstructed, and you've checked for faulty
components. Now you're ready to light the stove.
WARNING
!
PLEASE REFER TO THE USER'S
MANUAL FOR ALL CAUTIONS, SAFETY,
AND WARNING INFORMATION
PERTAINING TO THE LIGHTING AND
OPERATION OF THE STOVE.
LEAVE THIS INSTALLATION MANUAL
!
WITH THE APPLIANCE FOR FUTURE
REFERENCE.
28