Heat & Glo Townsend I Installer's Manual page 12

9
Straight Vertical Vent System
When a vertical run of 12 feet and higher is attached
directly to the top of the stoves, further baffling is
necessary to maintain high efficiency. A round baffle
with two tabs on each side is included in the manual bag
assembly. To install the round baffle follow these steps:
1. Remove the front of the casting. Refer to cast front re-
moval on page 6.
2. Remove the glass assembly. Refer to glass removal
on page 6.
3. Remove logs and set aside.
4. Disassemble the square baffle by unfastening four
screws located inside top of the firebox. See Figure 6.
5. Unfasten the two screws on the existing round baffle,
and replace it with the new round baffle. Note: The new
round baffle is bigger than the existing round baffle al-
ready on the unit.
6. Re-install the square baffle removed in Step 4.
!
Figure 6