Additional Tools Required; Preparing The Surface Mount For An Indoor Installation - Bosch VEZ Series Mounting Manual

AutoDome Easy II
4.1.1

Additional Tools Required

–
–
–
–
–
–
–
–
–
4.1.2 Preparing the Surface Mount for an Indoor
Installation
The following instructions detail the preparation necessary to
prepare the surface and the steps to install a Surface Mount.
1.
Bosch Security Systems, Inc.
Appropriate straight slot screwdrivers
No. 2 Phillips screwdriver
Appropriate tool for cutting a hole in drywall or ceiling tile
(if applicable)
4 in. x 4 in. Junction box with 90 mm (3.54 in.) mount
holes (indoor installation)
Four (4) M4 or #10 pan head screws of an appropriate
length to screw deep enough into the surface (outdoor
installation)
One (1) ground
T-10 Torx wrench
VEZ-A2-JW or VEZ-A2-JC Surface Mount Junction Box,
required for an outdoor installation
AutoDome Easy II Outdoor Camera, required for an
outdoor installation
Determine a secure location for the surface mount dome.
R50.6
(1.99)
Figure 4.1 Indoor Surface Mount Dimensions
Mounting Manual
Installing a Surface Mount | en
ø
153.0
(6.02)
134.7
(5.3)
F.01U.141.122 | 2.0 | 2010.02
11