Bosch VEZ Series Mounting Manual page 24

24 en | Installing a Wall Mount
2.
3.
4.
5.
CAUTION!
You must ensure that the gasket is attached to the retaining
ring as shown above to ensure an environmentally tight seal.
F.01U.141.122 | 2.0 | 2010.02
Use the four (4) holes at the end of the Wall Mount as a
template to mark the position where the holes should be
drilled to secure the mount.
Drill the four (4) holes in the installation location, screws
not supplied. Use a minimum screw length of 10 mm
(.39 in.).
Drill a fifth hole (maximum of 20 mm) in the center of the
four-hole pattern used to mount the arm.
Ensure that the gasket is attached to the retaining ring. If
the gasket and the retaining ring are separate:
a. Locate the flat side of the gasket and the recessed
side of the retaining ring.
b. Thread the flat side of the gasket (item 1, below) onto
the recessed side of the retaining ring (item 2). The
illustration below shows a cross-section of the gasket
on the retaining ring.
Mounting Manual
AutoDome Easy II
Bosch Security Systems, Inc.