Advertisement
Megapixel IP Cameras
1
Quick Install Guide
1.1
Camera installation using PoE switch
Equipment needed:
–
–
–
CAUTION!
!
Never supply power via the Ethernet connection (PoE) when
power is already supplied via the power connector.
1.
2.
3.
4.
5.
6.
1.2
Camera installation with direct connection
to PC
Equipment needed:
–
–
–
CAUTION!
!
For 9-12 VDC units, voltage applied to the unit's power input
should not exceed 12.3 VDC.
Bosch Security Systems
PC with 100baseT or better network port
100 baseT or better network switch with PoE capability
2 CAT5 Network cables
Attach camera to a PoE port of the network switch with
CAT5 cable.
Attach (non-PoE) switch port to the PC LAN port with
CAT5 cable.
Manual iris lens: Check the lens to make sure the F-Stop is
between F2.8 and F4.0.
DC-iris lens: Ensure that the DC-iris cable is plugged into
the iris connector on the rear of the camera.
Plug in the switch's power cord.
A yellow LED on the back of the camera should light up
after a few seconds.
–
This LED indicates that a link to the computer has
been established.
–
A green LED will blink when the camera is accessed.
PC with 100baseT or better network port
1 CAT5 cross-linked network cable
Power supply unit: 9-12 VDC, 500 mA.
Quick Install Guide
Quick Install Guide | en 4
F.01U.032.595 | V 1.0 | 2007.03
Advertisement
