Connecting Your Monitor - IBM ThinkVision L170 User Manual

L170_E.fm Page 6 Friday, February 21, 2003 4:32 AM

Connecting your Monitor

Be sure to read the 'Safety'
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
6
1. Turn off your computer and all attached devices.
2. Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card might be blue to match the blue
connector on your monitor's video cable.
* If the power cord supplied is not attached to the monitor, please follow
the below instruction:
b
a. Tilt monitor all the way forward.
b. Hold the top of the cable cover (a) and pull it off.
c. Gently lift the stand cover (b) along the top and then slide it
backwards and off the stand.
d. Connect the power cord to the power port on the back of your monitor.
e. Replace the rear covers.
3. Insert the plug into a properly grounded electrical outlet.
forward tilt
a