Installation Instructions; Window Requirements; Basic Tools Needed; Safety Instructions - Daewoo DWC-100R Use & Care Manual

Window type room air conditioner

Hide thumbs

Table Of Contents

Table of Contents

• WINDOW REQUIREMENTS

These instructions are provided for a standard double hung window

or mobile home double hung window installation in windows 27.5

inch (699mm) to 36 in (914mm). The upper and lower sash must

open sufficiently to allow a clear vertical opening of 15 in (381mm)

from the bottom of the sash to the window sill.

Select a centrally located window on the side of the room that

receives the least direct sunlight. There should be no obstruction to

air flow either inside(i.e curtains) or outside (i.e fence, wall or

bushes).

Read this entire installation manual thoroughly before beginning the

installation.

Make sure you have the necessary tools and other materials for the

job. Study the illustrations in these instructions to become familiar with important details of the installation

process.

Read the Use & Care manual to become familiar with the operation of your room air conditioner.

IMPORTANT :

It is important, both for your personal safety and to avoid possible damage to your

home, that you observe the safety instructions that are given.

After installing the unit, re-read these instructions to make sure you have completed each step and all parts are

fastened in place for a secure installation.

For best results, perform the installation procedure in the order given. Doing so will minimize the time required

to install the unit.

• BASIC TOOLS NEEDED

• Standard screwdriver

• Carpenter's level

• Electric drill

• SAFETY INSTRUCTIONS

CAUTION

• The air conditioner shall be installed in accordance with the national wiring regulation.

1. Install an exclusive main power switch (main circuit breaker) or GFI (Ground Fault Interrupted)

switch.

2. Be sure to use grounded power source.

3. Power source for DWC-100R, DWC-121R is 115V and DWA-122R, DWA-150R, DWA-151R is

208~230V.

4. Consumer must pay charges for wiring and installation.