Step1-Prepare Components For Installation; Step2-Prepare Window For Installation; Step3-Preparation Of Chassis - Daewoo DWC-100R Use & Care Manual

• Step 1 - Prepare Components For Installation
Parts for installation are as follows;
• Sill Bracket (2 pieces)
• Window Kit Left side (Frame 'L+Shutter) - (1 piece)
• Window Kit Right side (Frame 'R+Shutter) - (1 piece)
• Sash Bracket (1 piece)
• DRAIN, DRAIN seal
• Frame Guide Lower - (2 pieces)
• Levelling Screw (Machine M8x45) - (2 pieces)
• 1 inch Screw (M5x30) - (4 pieces)
• 5/8 inch Screw - (M4x16) - (8 pieces)
• DRAIN SCREW (M4x8) - (2 pieces)
• 1/4 inch Screw (M4x6) - (8 pieces)
• Window Seal A, B (2 pieces)
Sill Bracket (2 pieces)
Sash Bracket
(1 piece)
• Step 2 - Prepare Window For Installation
1. Inspect window track, sash and sill to be sure they are strong enough to hold an air conditioner.
2. Measure width between window frame to be sure instant mount will fit in the window. Instant mount models are
designed for Windows 27.5 inch (699mm) to 36 inch (914mm) wide.
3. Mark the center of Window sill with pencil.
4. Insert Screws (Type A) into the sill bracket.
5. Attach Sill bracket to window sill using two Screws (Type B) by each bracket. The outside edge of window bracket
should be 11.8 inch (300mm) from center line.
6. Adjust Screw (Type A) so that Sill Bracket have a slight tilt by using carpenter's level meter.
• Step 3 - Preparation of Chassis
1. Pull the Air-filter out of the Front Grille.
2. Loosen screw which fasten Front Grille with driver.
Frame Guide Lower
(2 pieces)
DRAIN Seal
DRAIN
NOTE: Use Screw
(Type D) only
Screw Type B
• SCREW TYPE
Type A Type B
SHAPE
SPEC M8 x 45 M5 x 30
Q'TY 2
Window
Shutter
(2 pieces)
Window kit Frame
Window kit Frame
Left side (1 piece)
Right side (1 piece)
SILL BRACKET
Screw Type A
5
Type C Type D
M4 x 16 M4 x 8
4 8 2
Window Seal A (1 piece)
Window Seal B (1 piece)
SASH
600mm
300mm
720~915mm
699~914mm
Type E
M4 x 6
8