Page 2
Illustration 1 – Back panel Illustration 2 – Front panel...
Page 3
Set up procedure Before connecting the ECC-1 to the mains, check that the main voltage indicated on the rear panel corresponds to the line voltage in the territory where you intend to use the unit.
Page 4
See illustration 1. Outputs Balanced analogue operation: Use an XLR interconnect and connect the right and left outputs on the ECC-1 to the right and left inputs on the integrated amplifier or preamplifier Unbalanced analogue operation: Use Phono interconnects and connect the right and left outputs on the ECC-1 to the right and left...
Page 5
When switching off your system First turn off the amplifiers, and then turn off the ECC-1. XLR configurations XLR output: 1 = ground 2 = positive 3 = negative Technical specifications ECC-1 The following technical data were measured on randomised test objects and are typical data.
Page 6
Important Notice For optimal sonic performance, the ECC-1 should be burned in for a minimum time of 72 hours. If the ECC-1 has been switched off, allow two hours of warm-up for optimal sonic performance. Proper ventilation is important. Never cover the ventilation area.