Advertisement
Quick Links
Advertisement
Related Manuals for ELECTROCOMPANIET EC 4.9
Summary of Contents for ELECTROCOMPANIET EC 4.9
- Page 1 EC 4.9...
- Page 2 1 pcs inspection card. Set up procedure Before connecting the EC 4.9 to the mains, check that the main voltage indicated on the rear panel corresponds to the line voltage in the territory where you intend to use the unit.
- Page 3 SPAC Multi is reserved for future use. DATA: Connect an USB cable from the DATA port to a PC to upgrade the software on the EC 4.9. REMOTE CHARGE: Connect the remote ECT2 (sold separately) to this port to charge the remote.
- Page 4 In daily operation, switch off the EC 4.9 by turning the volume control down. When the EC 4.9 is not to be used for a long period of time, use the main switch to turn the unit off. Then disconnect the AC main cord for maximum safety.
- Page 5 1 – 200 kHz 1 – 200 kHz Channel separation > 120 dB > 120 dB Power consumption (no load or signal) 30 W The EC 4.9 is DC coupled from input to output. Dimensions Width: 483 mm Depth: 405 mm...
-
Page 6: Important Notice
Important Notice For optimal sonic performance, the EC 4.9 should be burned in for a minimum time of 72 hours. If the EC 4.9 has been switched off, allow two hours of warm-up for optimal sonic performance. Proper ventilation is important. - Page 7 Illustration 1 – Back panel Illustration 2 – Front panel...
- Page 8 Illustration 3 – Channels used Source Input channels used Output channels used Additional information In 1 In 1. Front Left, Front Front Left, Front Right, 6 Channel Right, Sub, Surround Left, Sub, Surround Left, Surround Right, Centre Surround Right, Centre In 1 In 1.