10/100 Ethernet Lan Port Tests - Allied Telesis AT-8600 Hardware Reference Manual

26
Figure 6: Example output from the show test command
Board ID Bay Board Name
----------------------------------------------------------------------------
Base 238
Uplink 88 1
Interface State
----------------------------------------------------------------------------
port1 no test
port2 no test
port3 no test
port4 no test
port5 no test
port6 no test
port7 no test
port8 no test
port9 no test
port10 no test
port11 no test
port12 no test
port13 no test
port14 no test
port15 no test
port16 no test
port17 no test
port18 no test
port19 no test
port20 no test
port21 no test
port22 no test
port23 no test
port24 no test
port26 no test
asyn0 no test
C613-03080-00 REV G

10/100 Ethernet LAN Port Tests

A loopback plug is required to run the first part of the Ethernet LAN test. See
"Testing Switch Interfaces" on page 27
plug. To start an Ethernet interface test, use the command:
enable test int=portn
where n is the Ethernet interface number. The test runs about 4 minutes. You
can use the following command to display the test progress and results:
Display test results with the command:
show test
The following figure shows example output from the this command.
8624 AT-8624T/2M
AT-A46
Result
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
for details of how to make a loopback
Rev Serial number
M1-1 12345678912345
P1-0 98765432198765
Duration
Type (minutes) Data( %OK )
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
AT-8600 Series
Details
Control
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -