Allied Telesis AT-8600 Hardware Reference Manual page 14

14
C613-03080-00 REV G
Message
FAIL: BBR test. Error address =
location
FAIL: BBR test, only 16k bytes
found
INFO: Self tests complete
INFO: Downloading switch
software
ERROR: Code load retried
FAIL: Code load failed
Force EPROM download (Y) ?
INFO: Initial download
succeeded
INFO: Downloading
compressed release. This may
take up to 1 minute...
INFO: Loading software into
memory. This may take up to 1
minute...
INFO: Executing configuration
script <script-name>
INFO: Switch startup complete The startup process is complete and the switch is ready. If
Description (Continued)
BBR size/location test failed at the given location. The test
at this location failed, indicating the end of memory, but a
valid location was discovered in the 255 long words
following this location. The BBR system must be replaced.
Contact your authorised distributor or reseller.
The BBR size/location test completed, but only the
displayed amount of memory was found. This amount is
less than the minimum required to run the switch
software.
Startup tests have finished.
The process of downloading the switch software and
vector table from ROM is about to begin.
Loading code from ROM to RAM failed. The load is retried
a number of times, and the error message is displayed
each time it fails. The fail message is displayed if the switch
reaches the maximum number of attempts.
Prompt that lets you override
sequence, typically when troubleshooting.
Startup tests and download are complete, and the switch
software is about to be started.The release is now
decompressed. This may take a few seconds.
The main switch software is decompressed before being
loaded into RAM.
Configuration commands in the given script file begin
executing if selected by the user. If the script has an error,
appropriate error messages are displayed.
devices connected to it are sending traffic, then the switch
begins switching operations.
AT-8600 Series
the standard startup