How To Connect - Strong SRT 5006 User Manual

How to Connect

For connection of the SRT 5006 there are number of
alternatives depending what is your preference and
the connection types on your TV.
Please connect by either of the following methods A.
B. C. (D. is mandatory for antenna connection)
IMPORTANT: Refer to page 6 of the Users Manual for
the connector reference numbers listed below.
A. Component Connection
for Y, Pb, Pr
You can connect to your TV with the supplied RCA
component cable to give you video. For audio connect
with the supplied RCA audio cables, this will give you
MPEG-2 stereo for audio.
If you require Dolby Digital Audio Output (through
you're Dolby Digital Decoder Amplifier) please refer to
Note: DOLBY DIGITAL AUDIO.
Connector 5
Component Y, Pb, Pr
RCA cinch component video output
Connector 6
AUDIO Right/Left (Red/White)
RCA cinch Right/Left audio output
B. Separate S-Video (Y/C)
Connector
If your TV includes a 4-Pin Mini Din S-Video
connector, you may choose to connect in this way.
Connector 9 SVHS S-Video
S-Video connector (connector 9) on the rear panel
and unit can be connected to the TV this way. (You
will need to purchase S-Video Lead separately)
Important: Using this separate S-Video (Y/C) for your
video connection, you will need to make connections
for audio.
For audio, this can be done by using the supplied
RCA cable by connecting to Connector 8 for Right
and Left Audio (RCA Red/White), and then connect to
appropriate RCA audio connectors of your TV.
These Left (White) & Right (Red) RCA Audio
connections will provide MPEG-2 Stereo.
If you require Dolby Digital Audio Output (through
you're Dolby Digital Decoder Amplifier) please refer to
Note: DOLBY DIGITAL AUDIO.
12