Installing Management Utilities; Nec Esmpro Agent - NEC Express5800 320Lb User Manual

5-2 Procedures after Completion of Installation

Installing Management Utilities

The "NEC EXPRESSBUILDER" CD-ROM, "Linux for NEC Express5800/ft series Back Up
CD-ROM 1", "Linux for NEC Express5800/ft series Back Up CD-ROM 2" are shipped with the
NEC Express5800/ft series.
"Linux for NEC Express5800/ft series Back Up CD-ROM 2" contains "NEC ESMPRO Agent" for
monitoring the NEC Express5800/ft series, and "NEC EXPRESSBUILDER" contains "NEC
ESMPRO Manager" for managing the NEC Express5800 series. Install and setup these utilities in
the NEC Express5800/ft series or the computer (management PC) that manages the NEC
Express5800/ft series.

NEC ESMPRO Agent

NEC ESMPRO Agent is a utility to monitor the operating status, the configuration information, the
failure occurrence status of hardware and software on the NEC Express5800/ft series. When it
detects some problems, it sends messages to the computer in which the NEC ESMPRO Manager is
installed.
NEC ESMPRO Agent is already installed to the hard disk drive of the server at the time of shipment.
Also, it is automatically installed when Linux for NEC Express5800/ft series is installed. However,
you still need to set up according to your environment for operating NEC ESMPRO Agent. See
"Preparation before Setup" described later to set up.
IMPORTANT:
Make sure that NEC ESMPRO Agent is installed because it is
indispensable for continuous operation of NEC Express5800/ft series.
Operation Environment
NEC ESMPRO Agent can be operated in the hardware and software environments shown below.
Hardware
•
Installation system
Software
The following packages are required.
•
ucd-snmp
•
ucd-snmp-devel
•
ucd-snmp-utils
•
newt
•
newt-devel
•
portmap
NEC Express5800/ft series