NEC Express5800 320Lb User Manual page 60

4-16 Linux Setup
The RAID menu will be displayed.
4.
Enter "1" and then press Enter.
"Status (Raid)" (the disks' current status of RAID) will be displayed.
(Display example of the RAID status)
[Status(Raid)]
-----------------------------------------------------------------------------------------------
name
md0
md1
md2
md3
md4
md5
md6
-----------------------------------------------------------------------------------------------
"name" is the name of a software RAID device.
"partition" is a mount point or a swap. If this field is blank, RAID is configured but not
mounted as a file system.
"member" is the information of the member configuring RAID. The information will be
displayed in the following format for the number of members.
(Slot number) name
If the status is error, (F) is marked on the right. In such case, you need to correct RAID.
status indicates the status of RAID. The following are the descriptions of the status
messages.
DUPLEX
RESYNCING (X.X%)
RECOVERY (X.X%)
SIMPLEX
ERROR
partition label status
/boot /boot DUPLEX
/user /usr DUPLEX
/home /home DUPLEX
/var /var DUPLEX
/ / DUPLEX
/tmp /tmp DUPLEX
swap DUPLEX
member
(1)sda1 (4)sdd1
(1)sda5 (4)sdd5
(1)sda10 (4)sdd10
(1)sda6 (4)sdd6
(1)sda8 (4)sdd8
(1)sda9 (4)sdd9
(1)sda7 (4)sdd7
: Normal status.
: Being synchronized. When completed, it becomes
DUPLEX.
: Being recovered. The members with "-" mark on the
member field have not been built yet.
: Only one side of RAID is built. If two members are
displayed on the member field, the member with "-"
mark is on standby before RECOVERY status. If
only one member is displayed, recovery is required.
: ERROR status. The members of RAID do not exist.