Enabling Raid Feature - NEC Express5800 120Li User Manual

4-32 Configuring Your Server

Enabling RAID Feature

To configure a hard disk drive as RAID drive, change setting of RAID configuration jumper switch
on mother board.
NOTE:
disk drive.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
The factory-set value is to use the hard disk drive as a single
Do not disassemble, repair, or alter the server.
Do not remove the lithium battery.
Make sure to complete board installation.
Do not install the server on a rack with leaving covers removed.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
WARNING
CAUTION