Healthrider Crosstrainer 950 S Elliptical User Manual page 8

8. Identify the left Pedal Spring (11), which is marked with
a sticker. Attach the Left Pedal (13) to the left Pedal
Spring with an Adjustment Bolt (80), an M10 Washer
(78), an M10 Split Washer (59), and a Pedal Knob (81)
as shown. Note: The Left Pedal can be attached in
several positions using the five positions in the Left
Pedal.
Attach the Right Pedal (not shown) in the same way.
Make sure that both Pedals are in the same pedal
position.
9. Identify the Left Rear Spring Bracket (12) on the left
Pedal Spring (11). Apply a thin coat of grease inside of
the Pedal Arm Bushings (37) in the Left Rear Spring
Bracket and to the axle on the left Disc Crossbar (16).
Next, slide a Spring Spacer (63) onto the axle; make
sure that the Spring Spacer is turned so the flat
side is facing the elliptical crosstrainer. Next, slide
the Left Rear Spring Bracket onto the axle. Then, slide
an M10 Large Washer (88) onto an M10 x 27mm Patch
Screw (40), and tighten the Patch Screw into the axle.
Next, hold the lower end of the left Handlebar Leg (5)
inside of the Front Spring Bracket (76) on the left Pedal
Spring (11). Apply grease to an M10 Bolt Set (74).
Attach the Handlebar Leg to the Front Spring Bracket
with the Bolt Set. Do not overtighten the Bolt Set;
the Handlebar Leg must pivot freely.
Attach the right Pedal Spring (not shown) to the right
side of the elliptical crosstrainer in the same way.
Tighten the M6 x 25mm Button Screw (7) into the
Upright (2). Turn the Upright Knob (43) clockwise until it
is tight.
See step 7. Tighten the M8 x 45mm Button Bolts (50)
in the Handlebar Legs (5).
10. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
8
13
11
9
37,
Grease
11
12
88
40
76
Grease
74
11
8
80
78
59
81
16, Grease
63
7
5
74
2
43