Healthrider Crosstrainer 950 S Elliptical User Manual page 14

HOW TO USE A PRESET PROGRAM
1
Turn on the console.
See step 1 on page 13.
2
Select one of the six preset programs.
Each time the
console is turned
on, the manual
mode will be
selected. To
select a preset
program, press
the Program
Select button repeatedly until the number 1, 2, 3,
4, 5, or 6 appears in the upper right corner of the
display.
The profiles numbered 1 through 6 on the right
side of the console show the resistance and pace
settings for the preset programs.
3
Start the program.
To start the program, simply begin pedalling.
Each preset program consists of either twenty or
thirty, one-minute periods. One resistance setting
and one pace setting are programmed for each
period. (The same resistance setting and/or pace
setting may be programmed for consecutive peri-
ods.)
During the program, the resistance of the elliptical
crosstrainer will automatically change as shown
by the applicable profile on the console. Note: If
the current resistance level is too high or too low,
you can change the resistance level by pressing
the + or – button. However, when the current peri-
od of the program is completed, the resistance
level will automatically change if a different resis-
tance setting is programmed for the next period.
The target pace
settings for the
program will be
shown by the
right pace indica-
tor in the display.
(The left indicator
will show your actual pedalling pace.) As the right
indicator changes in height during the program,
adjust your pace so that both indicators are at the
same height. If your pace is slower than the cur-
rent target pace, the increase arrow will appear in
the display to prompt you to increase your pace; if
your pace is faster than the target pace, the
decrease arrow will appear. Important: The pace
settings for the program are intended only to
provide a goal. Your actual pace may be slow-
er than the pace settings, especially during
the first few months of your exercise program.
Make sure to pedal at a pace that is comfort-
able for you.
During the program, the display will show the time
remaining in the program. When no time remains,
the program will be completed. If you continue
pedalling after the program is completed, the dis-
play will continue to show your exercise feedback.
4
Follow your progress with the feedback modes.
See step 4 on page 13.
5
Measure your heart rate if desired.
See step 5 on page 13.
6
When you are finished exercising, the console
will automatically turn off.
See step 6 on page 13.
14
Increase Arrow