Table of Contents
Advertisement
50
Maintaining and Troubleshooting the Gateway ALR 8300 Server
Installing software and drivers
The procedure for installing software and drivers is usually specific to the
operating system you will run on the server. Here are some tips.
Installing the USB driver
To use a USB device, you must install the USB driver in a computer
running Windows 95. A 3.5-inch disk labeled "Integrated Controller UATA
files for Win 95" was shipped with your computer. You must use this disk
to install the USB driver.
Start the computer.
1.
2.
Put the 3.5-inch disk labeled "Integrated Controller UATA files for
Win 95" into the disk drive.
Open the
3.
Readme.1st
After you have installed the USB driver, install the USB device by attaching
it to a USB port on the rear panel. Check the device documentation for
additional information to see if you must install software for the device.
Installing video drivers
The integrated video controller on the system board uses standard drivers
provided with the system utilities diskettes. For those running Windows NT
in particular, use the driver provided on the utilities diskettes (Cirrus Logic
Windows NT 4.0 diskette) not those provided on the Windows NT
installation CD-ROM. The drivers provided on the Windows NT CD-ROM
may not function correctly.
Video driver installation varies depending on the operating system that you
run on the server. Refer to the documentation for the operating system for
specific instructions.
file and follow the instructions on screen.
Advertisement
Table of Contents
Troubleshooting
