Gateway E3400 System Manual page 106

Error Message
Invalid password.
Keyboard clock line failure.
Keyboard controller failure.
Keyboard not detected.
Keyboard stuck key failure.
Memory errors were detected
while the system powered up.
Memory size error.
Non-system disk or disk
error.
Not enough memory.
Solutions
Enter your password again, making sure to
enter it correctly. Keep in mind that some
passwords are case-sensitive.
If you do not know the password, you may
need to reinstall the software you are trying to
access.
Startup passwords are stored in BIOS. If this
password has been set and is unknown, you
may be able to reset the password through
system board jumper settings.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
See "The keyboard does not work." on
page 92 for possible solution.
Turn off the system, then check the keyboard
cable.
Remove any objects that may be resting on the
keyboard, then restart the system.
Check for sticky keys. Clean the keyboard if
necessary.
See "Memory errors were detected during
system start up." on page 86 for possible
solution.
Enter the BIOS Setup utility, then save the
memory configuration.
Eject the diskette, then press E
If the diskette is bootable, check it for errors.
Close all programs that are not currently in
use.
.
NTER
Error messages
99