Speaker Config - Denon AVR-X4000 Owner's Manual

Contents
2 Main Pre-amps
Selects the PRE OUT connector that is connected to the external power
amplifier used in MAIN ZONE when "Assign Mode" (vpage 181) is
set to "9.1ch(SB/FH/FW)".
Surround Back (Default) : The surround back left and right pre-amp
outputs are connected to an external
amplifier.
Front Height : The front height left and right pre-amp outputs are
connected to an external amplifier.
Front Wide : The front wide left and right pre-amp outputs are
connected to an external amplifier.
Front : The front left and right pre-amp outputs are connected to an
external amplifier.
Front panel Display
Connections Playback
Rear panel
Settings

Speaker Config.

Indicate speaker presence and select speaker size categories based on
bass reproduction capability.
2 Front
Set the front speaker size.
Large (Default) : Use a large speaker that can adequately play back very
low bass frequencies.
Small : Use a small speaker that has inadequate playback capacity for
very low bass frequencies. Note that for most multi-channel
speakers, this is the best choice.
%
• When "Subwoofer" is set to "No", "Front" is automatically set to "Large".
• When "Front" is set to "Small", "Center", "Surround", "Surr. Back", "Front
Height" and "Front Wide" can not be set to "Large".
2 Center
Set the presence and size of the center speaker.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when a center speaker is not connected.
182
Remote
Tips Appendix
Index