Initializing Registered Preset Codes; Specifying The Zone Used With The Remote Control Unit; Resetting The Remote Control Unit - Denon AVR-X4000 Owner's Manual

Contents

Initializing registered preset codes

1
Press and hold down AVR and OPTION until the DEV,
TV and AVR indicators on the remote are flashing green,
then release.
Front panel Display
Connections Playback
Rear panel
Settings
Specifying the zone used with the
remote control unit
To prevent accidental misuse, you can set the zone for which the remote
control unit is used.
1
Press and hold down MAIN or ZONE2 or ZONE3 and
SETUP until the DEV, TV and AVR indicators on the
remote are flashing green, then release.
MAIN : When only using "MAIN ZONE"
2 : When using "MAIN ZONE" / "ZONE2"
3 (Default) : When using "MAIN ZONE" / "ZONE2" / "ZONE3"

Resetting the remote control unit

All the settings are restored to their defaults.
1
Press and hold down DEVICE MENU until the DEV, TV
and AVR indicators on the remote are flashing green,
then release.
2
Press 9, 8 and 1, in that order.
The remote control unit operation mode indicator flashes twice.
All the settings are restored to their defaults.
208
Remote
Tips Appendix
Index