Hdmi Control Function; Setting Procedure - Denon AVR-X4000 Owner's Manual

Contents

HDMI control function

A recent addition to the HDMI standard is CEC (Consumer Electronics Control), which allows control signals from one device to communicate with
another device via the HDMI cable connection. Not all HDMI-equipped devices have this capability.

Setting procedure

1
Set the HDMI output connector corresponding with the
HDMI control function.
Set "HDMI Control" (vpage 163) to "On".
2
Turn the power on for all the devices connected by
HDMI cable.
3
Set the HDMI control function for all devices connected
by HDMI cable.
• Please consult the operating instructions for the connected
devices to check the settings.
• Carry out steps 2 and 3 should any of the devices be unplugged.
4
Switch the television input to the HDMI input connected
to this unit.
5
Switch this unit input to the HDMI input source and
check if the picture from the player is ok.
6
When you turn the TV's power to standby, check that
the power of this unit also goes to standby.
Front panel Display
Connections Playback
Rear panel
Settings
NOTE
• Some functions may not operate depending on the connected TV or player. Check
the owner's manual of each device for details beforehand.
• The HDMI ZONE2 function is not compatible with the HDMI control function.
• When the HDMI ZONE2 function is used with "HDMI Control" in the menu set to
"On", the HDMI ZONE2 function may not fully work.
125
Remote
Tips Appendix
Index