Replacing The Power Supply - Cisco TelePresence Server 7010 Installation Manual

Replacing the power supply

Replacing the power supply
CAUTION: Only replace the power supply under the guidance of Cisco customer support.
The power supply will be installed when you receive your TelePresence Server. To replace the power supply:
1. Remove the power cable from the unit to disconnect the power.
2. Push the power supply latch to the right and grip the handle firmly. Pull the power supply to remove it.
3. Insert the replacement power supply so that the latch is at the bottom left.
4. Push the power supply firmly into the unit until the latch engages.
5. Reconnect the power cable.
Figure 3: Replacing the power supply
Cisco TelePresence Server 7010 Installation Guide Page 11 of 14