Pin Programming - Clifford Concept 650MkII Owner's Manual

G919730P_01-07.qxd 1/12/07
ters that have been lost, stolen, or incorrectly programmed
into the system.
After entering this feature press any button on the transmit-
ter; the siren will chirp to indicate that all transmitters have
been erased from memory.

pin programming

A PIN code can have one to four digits; each digit can be from 0-9.
n n o o t t e e : : A PIN code cannot begin with a zero.
Programming Procedure
1. Enter the feature location in the user programming grid.
Press twice and
2. Immediately press and release
switch.
3. Select each digit by pressing
to enter the number into the system. To enter a zero,
press
To program a PIN code of 1032:
a. Press and release
hear one chirp.
b. Press and release
after programming a zero.
c. Press and release
once. You will hear three chirps.
28
3:39 PM Page 28
once
of the PlainView 2 Valet
1-9 times, and then press
only.
once and
once. You will not hear a chirp
three times, and then press
once. You will