Transmitter Valet Mode - Clifford Concept 650MkII Owner's Manual

G919730P_01-07.qxd 1/12/07
3. After the last digit of the pin code is entered:
The LED status indicator will illuminate continuously if you are entering
Valet Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:
1. Turn the ignition on. The system will then auto-

transmitter valet mode

The operations described in this section refer to transmitter buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration transmitter. This may not be how
your transmitter is set up.
To enter Valet Mode, press
tus indicator will illuminate continuously if you are entering Valet
Mode, or will turn off if you are exiting Valet Mode.
© 2 0 0 7 d i re c t e d e l e c t ro n i c s
3:39 PM Page 13
a. To disarm the system: press and release
b. To enter valet mode: Press and hold
three seconds.
matically exit Valet mode.
twice and then
.
for
. The LED sta-
13