Table of Contents
Advertisement
peripheral plug-in harnesses
super bright blue led, 2-pin white plug
The super bright LED operates at (+) 2V DC. Make sure the LED wires are not short-
ed to ground as the LED will be damaged. Multiple LEDs can be used, but they must
be wired in series. The LED can be top-mounted or flush-mounted. If top-loading the
LED with a bezel, the LED fits into a 5/16-inch mounting hole. If flush-mounting the
LED from the back of a panel, drill a mounting hole using a 17/64-inch drill bit. Be
sure to check for clearance prior to drilling the mounting hole.
plain-view valet
The Valet/Program switch should be accessible from the driver's seat. It plugs into the
blue port on the side of the unit. The switch is coded for protection so it need not be
hidden. Consider how the switch will be used before choosing a mounting location.
Check for rear clearance before drilling a 9/32-inch hole and mounting the switch.
sensor harness, 4-pin connector
red and black wires
These wires supply 12 volts when the system is armed and ground to the sensor.
18
www.directed.com
Advertisement
Table of Contents
