Ultrasecure Auto-Immobiliser - Clifford Concept 650MkII Owner's Manual

G919730P_01-07.qxd 1/12/07
d. Press and release
once. You will hear two chirps.
4. Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming
sequence or the new code will not be set.
1. Turn on the ignition.
2. Enter the new PIN code.
3. Press and hold
LED turns on: New PIN code is learned and program-
ming is complete.
LED stays off: New PIN code is not learned and the sys-
tem reverts to the old PIN code. Redo the programming
sequence.

ultrasecure auto-immobiliser

The built-in dual circuit immobiliser autoimmobilises (arms automatical-
ly), 30 seconds after the ignition has been turned off. (This feature is a
Thatcham and EC requirement and, therefore is not programmable.)
© 2 0 0 7 d i re c t e d e l e c t ro n i c s
3:39 PM Page 29
two times, and then press
for three seconds.
29