Manual Programming Instructions - Clifford Concept 650MkII Owner's Manual

G919730P_01-07.qxd 1/12/07

manual programming instructions

It is a good idea to document changes by taking note of all feature
changes made in programming mode.
To enter the User Selectable Features programming:
1. Ignition on - Turn the ignition to the run position or start the
engine.
2. Hold/Chirp/Release - Press and hold
heard and the LED turns on, then release the button. You
have now entered the feature selection position of the User
Selectable Features grid.
3. Column select - Press
desired column. After a pause the siren will chirp the same
number of times as the selected column for confirmation.
4. Feature select - Press
desired feature. The siren will chirp with each press. The fea-
ture can now be changed using the remote control.
5. Feature change - Press
tem chirps once, the feature has just turned off; if the sys-
tem chips twice, the feature has just turned on. If the fea-
ture has more than two settings, continue pressing
on the transmitter to toggle through the settings.
You can advance to any feature in the same column by
pressing
different column begin at step 4 within 60 seconds.
n n o o t t e e : : Refer to the Feature Descriptions sections of this guide for impor-
tant notes and descriptions of the system features and programming.
6. Exit programming - To exit programming mode turn the igni-
tion off or wait 60 seconds without pressing the PlainView 2
Valet switch. The siren will chirp three times to indicate pro-
© 2 0 0 7 d i re c t e d e l e c t ro n i c s
3:39 PM Page 21
the same number of times as the
the same number of times as the
on the transmitter. If the sys-
within 60 seconds; to program a feature in a
until a chirp is
21