Disarm/Valet Mode; Transmitter Valet Mode - Clifford CONCEPT 470 Manual

disarm/valet mode

Entering your pin code using the PlainView 2 Valet switch allows you
to disarm the system or enter valet mode without using the transmit-
ter. In valet mode, the security system will not arm, even with the trans-
mitter, but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To disarm or enter Valet Mode:
The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:

transmitter valet mode

© 2 0 0 6 d i re c t e d e l e c t ro n i c s
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2).
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release
b. To enter valet mode: Press and hold
three seconds.
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press
The LED will turn off.
.
for
for one second.
11