Transmitter Valet Mode; Battery Saver Mode - Clifford ARROW 5 Manual

3. After the last digit continue to hold
three seconds.
The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press
The LED will turn off.

transmitter valet mode

The operations described in this section refer to transmitter buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration transmitter. This may not be how
your transmitter is set up.
To enter Valet Mode, press
status indicator will light solid if you are entering Valet Mode, or will
turn off if you are exiting Valet Mode.

battery saver mode

After 48 hours in the armed state, the LED will decrease the flash rate to
1 / the normal rate; after 96 hours it will decrease to
2
© 2 0 0 3 d i re c t e d e l e c t ro n i c s , i n c .
for one second.
and simultaneously. The LED
1 / the normal rate.
4
for
11